ST-LINK/V2 is an in-circuit debugger and programmer for STM8 and STM32 microcontroller families. SWIM, SWD and JTAG programming interfaces are used to communicate with any STM8 or STM32 microcontroller.
STM32 applications use USB full speed interface to communicate with Atollic, IAR, Keil or other IDEs.
Features.
The programming device uses 5 V power from the USB 2.0 connector via a USB adapter from the standard connector to the Mini-USB.
The SWIM interface regulates the voltage from 1.65 V to 5.5 V.
Low-speed and high-speed modes are supported when SWIM is connected. ERNI connectors are standard vertical (Ref: 284697 or 214017) or horizontal (Ref: 214012) with pins with pins 2.54 mm pitch.
When connected via JTAG, programming voltage from 1.65 V to 3.6 V Standard JTAG cable 20-pin with a pitch of 2.54 mm on the connector.
Direct Firmware Upgrade Function (DFU).
The status light flashes while communicating with the PC.
Working temperature 0 to 50°С
Completion
-
ST-LINK/V2 debugger/programmer
-
USB Type A to mini-B cable
-
SWIM flat 4-pin cable with two 4-pin connectors, pitch 2.54 mm.
-
SWIM is flat with a standard ERNI connector at one end and a 4-pin connector with a 2.54 mm pitch. at the other end.
-
JTAG or SWD and SWV flat JTAG cable with 20-pin connectors.
The data presented in the product description are for reference only and may differ from those indicated by the manufacturer.
