This model of current clamp allows you to measure the value of the alternating current (AC) by a non-contact method, and also measure direct and alternating voltage, alternating current, resistance, temperature, and allow you to ring the circuit for an open circuit in the multimeter mode, using test leads.
The "Data Hold" function (holding of measurements) makes it possible to carry out current measurements by a non-contact method in hard-to-reach places where it is difficult to visually check the display readings.
Measuring functions:
- alternating current
- constant and alternating voltage
- resistance
- temperature
- continuity of the circuit (with a sound signal)
- "Data Hold" function
indication of an incorrectly selected measurement range; low battery indication.
SPECIFICATIONS
display: LCD 3 1/2 digit (1999)
sampling rate: 3 times/s
constant voltage (DC): 200mV/20V/200V/1000V, error ±(0.5%+1)
alternating voltage (AC): 200V/600V, error ±(1%+4)
alternating current (AC): 20A/200A/1000A, error ±(2.5%+5)
resistance: 200Ω/20kΩ/2MΩ, error ±(1%+1)
temperature, C: from 0 to 750°C, error ±(1%+3)
continuity of the circuit: beep when resistance
¦ <50 Ohm
maximum diameter of the measured wire: 28 mm
power supply: 1pc battery 9V 6F22 "Krona"
dimensions: 230 x 90 x 43 mm
weight: 320 grams
Accessories included:
set of measuring probes
K-type thermocouple (0 to 1200°C) with open junction ("ball")
soft case
The data presented in the product description are for reference only and may differ from those indicated by the manufacturer.
