Web Speech API is not supported by this browser. Install Google Chrome.
Voice input also works in Safari, Yandex, as well as mobile browsers Huawei, Opera and Samsung..
LED display of the temperature controller, easy to read.
The temperature of the heating plate is adjustable from 0°C to 200°C.
Temperature correction function: the surface area of the aluminum plate is relatively large, its temperature may vary slightly depending on significant changes in ambient temperature. The temperature correction function compensates for this potential discrepancy.
The built-in vacuum pump presses the display module against the plate, for this purpose, a field of holes of 70 x 40 mm with a pitch of 10 mm is provided in the surface of the plate. To ensure evacuation, a silicone mat 170 x 100 mm with the same field of holes is included with the heater.
The surface of the plate is ground, matt for the best fixation of the silicone mat, so that it does not move under the influence of lateral force when the cutting string is pulled.
On the long sides of the heating plate there are guiding tubes that are loosely fixed in the supports. Diameter of guides 10 mm, polished stainless steel. The plane of the guides is just below the plane of the slab. They are used as supports for pulling the wire string during gluing.
Technical data:
supply voltage: 220V+-10% 50 Hz
power consumption: 550W
built-in vacuum pump: 20 W
evacuation: 0.05 Mpa
heater plate size: 190 x 110 mm
overall dimensions: 260 x 160 х 110 mm
Warranty for all models of soldering stations and board heaters is 3 months.
The warranty does not apply to heating elements and soldering tips, which are consumables.
_______________________________________
For the repair of modern electronic equipment, especially portable mobile devices, special equipment is required without which some repair operations are simple cannot be performed at the proper level.
These operations include disassembling the display module (peeling off the glass), replacing microcircuits in BGA packages, working with components in ceramic packages and on ceramic printed circuit boards. Ceramics are critical to the heating rate and high temperature gradient of the working tool.
Using the most popular methods of dismantling components using a heated air stream (hairdryer) without bottom heating of the board increases the risk of warpage of the board due to local one-sided heating.
Preheating printed circuit boards allows you to reduce the operating temperature of the thermal tool, reducing the risk of damage to components from thermal shock.
New models of board preheaters allow to cover a wide range of repair work. This is due to the design of the heating plate - a brushed aluminum surface.
Smooth aluminum evenly heats the display module.
Leave your feedback or ask a question
Only this product is discussed here. Off topic comments will be deleted! Please follow the Commenting Rules.
The data presented in the product description are for reference only and may differ from those indicated by the manufacturer.
To carry out technical calculations and obtain the exact parameters of the goods, use the datasheets from the manufacturer's website.
If you need additional information, or you found an error in the description, or have other questions about this product, then our manager will help you: Ярослав
unknown
The data presented in the product description are for reference only and may differ from those indicated by the manufacturer.
