З 18.12.23 магазин в м.Дніпро за адресою вул.Новокримська 58 не працює.
Однак, наш інтернет-магазин відкритий для вас 24/7.
Усі місцеві замовлення можуть бути відправлені кур'єрськими службами.
Web Speech API is not supported by this browser. Install Google Chrome.
Voice input also works in Safari, Yandex, as well as mobile browsers Huawei, Opera and Samsung..
Home automation presupposes the presence of motion sensors that are capable of monitoring human movements. The simplest and most affordable device for monitoring changes in infrared radiation is PIR sensors. At the moment, not expensive models D203B, D204B, D205B are available. All of them allow the manufacture of inexpensive and simple devices for controlling human movement. These sensors are manufactured in metal housings. Sensors mainly differ in sensitivity, but structurally in the size of the light-sensitive window.
A compact sensor was designed to directly control low-voltage loads from 12 to 24 volts and load current up to 3 Amperes (the current depends on the MOS key).
The logic of the sensor is assigned to the PIC -controller, PIC10F222 is selected as the controller. The board can accommodate two MOS switches, which directly allow you to connect low-voltage loads up to 3 Amperes. The installation of an LED indicator is provided for monitoring the operation of the sensor. And also a connector for in-circuit programming of the controller.
The project under consideration is intended to create motion sensors that control lighting directly with a load on LED strips. Such sensors can be installed in cabinets, on bookshelves, table lighting, if there is a person in the sensor control zone, it will automatically turn on the light.
The circuit is a conventional amplifier based on two op amps. Their task is to amplify the variable component from the PIR sensor. Then the signal goes to the input of the ADC of the PIC controller, the function of which is the logical processing of the signal. MOS switches are connected to the peak controller, their power load control function. It is supposed to use LED strips with a current of up to 3A as a load. In this constructor, only one field-effect transistor is used, depending on the desired operating mode, it is soldered in place of V1 or V2. The transistors operate in antiphase, as follows, in normal mode V1 is open and the OUT1 output is pulled to minus. When the motion sensor is triggered, V1 closes and V2 opens, the OUT2 output is pulled to minus. Delay after triggering approx. 20 seconds, if during this time motion detection was not detected, then the sensor switches to security mode.
There is also a place on the printed circuit board for installing a downward linear stabilizer MCP1804T or RT9058-50GV, which will increase the supply voltage range. In this case, the circuit will need to be powered through the CON2 connector, the 4th and 5th pins.
А чувствительность - достаточная для детекции передвижения человека. Тут нет точных значений. Если речь о самом датчике, то вот на него даташит - Даташит. В нем есть данные о чувствительности и удельной детектируемости.
Да, дейвствительно в наборе 1 резистор. Можем в следующем заказе положить эти резисторы, только просьба напомнить в комментарии к заказу.
The data presented in the product description are for reference only and may differ from those indicated by the manufacturer.
To carry out technical calculations and obtain the exact parameters of the goods, use the datasheets from the manufacturer's website.
If you need additional information, or you found an error in the description, or have other questions about this product, then our manager will help you: Денис - Днепр
unknown