У зв'язку зі святкуванням Нового Року ми працюємо за наступним графіком: • з 31.12.24(Вт) по 02.01.25(Чт) не працюємо • з 03.01.25(Пт) працюємо в звичайному режимі.
Інтерет-магазин приймає замовлення цілодобово 24/7 !
Web Speech API is not supported by this browser. Install Google Chrome.
Voice input also works in Safari, Yandex, as well as mobile browsers Huawei, Opera and Samsung..
Steel 4 Minute Epoxy Adhesive "Could Be Stronger!" (color: steel).
The most popular and used classic "cold weld" formula. It is used for quick and reliable repair of various parts made of cast iron, steel, stainless steel, alloys based on aluminum and non-ferrous metals. 4 Minute Epoxy Adhesive Could Be Stronger (Steel) is an essential and effective remedy for emergency repairs.
Reinforced with steel microparticles, thanks to which it withstands increased shock alternating loads and vibration.
DD6540 is reinforced with steel microparticles, thanks to which it withstands increased shock and alternating loads and vibration
during polymerization and further does not shrink
waterproof
good resistance to oil, gasoline, solvents and most technical fluids
withstands sharp temperature changes
withstands long-term vibration and shock loads
does not corrode metals
during polymerization and further does not shrink
Application
Clean the surfaces to be connected from dirt, grease, rust, paint, etc. (it is recommended to sand with sandpaper and degrease).
Open the cap and pierce the safety membrane on each tube.
Squeeze an equal number of components 1 and 2 onto a clean surface.
Mix until a uniform color is obtained.
Apply the prepared mixture to both surfaces to be joined.
Join and compress surfaces to be repaired for adhesion.
Remove excess compound before it hardens! A solvent (acetone) can be used, provided that it does not damage the materials to be bonded.
The time from the moment of preparation of the mixture to the final fixation should not exceed 4 minutes (at +20°C).
The assembly of parts can be carried out in 15-20 minutes (depending on the temperature: at a lower temperature, the polymerization time increases, at an increased temperature, it decreases).
Repaired parts can be fully loaded after 2 hours.
Attention!DD6540 - If swallowed: Drink water or milk, do not induce vomiting and consult a doctor. Skin contact: wash with soap and water. In case of contact with eyes: rinse with water for 15 minutes. Keep out of the reach of children!
За полгода продано больше двух десятков, никаких претензий. Купившие клеят и радуются...)))
The data presented in the product description are for reference only and may differ from those indicated by the manufacturer.
To carry out technical calculations and obtain the exact parameters of the goods, use the datasheets from the manufacturer's website.
If you need additional information, or you found an error in the description, or have other questions about this product, then our manager will help you: Ярослав
unknown
The data presented in the product description are for reference only and may differ from those indicated by the manufacturer.
