У зв'язку зі святкуванням Нового Року ми працюємо за наступним графіком: • з 31.12.24(Вт) по 02.01.25(Чт) не працюємо • з 03.01.25(Пт) працюємо в звичайному режимі.
Інтерет-магазин приймає замовлення цілодобово 24/7 !
Web Speech API is not supported by this browser. Install Google Chrome.
Voice input also works in Safari, Yandex, as well as mobile browsers Huawei, Opera and Samsung..
This kit allows you to assemble a simple and powerful monophonic low-frequency amplifier with small dimensions, a minimum number of elements, a wide range of supply voltages and load resistances.
In a typical switching circuit (TDA7294), the ULF develops 70 W of sinusoidal power at a load of 4\6\8 Ohms at supply voltages of ±27V, ±31V, ±35V, respectively. Musical power in this case is 100 watts.
To power the device, you should use a power source with a power not less than the rated power of the amplifier. Additionally, you need to install filtering power supply capacitors with a capacity of at least 4700 μF (recommended 10000 μF) in each source arm. If a switching power supply is used, it must be remembered that the peak current consumption of the amplifier can be several times higher than the average.
WARNING!
The U1 chip must be installed on a heat sink with an area of at least 600 sq.cm. using heat-conducting paste, given that its body is connected to the negative terminal of the power source.
Leave your feedback or ask a question
Only this product is discussed here. Off topic comments will be deleted! Please follow the Commenting Rules.
The data presented in the product description are for reference only and may differ from those indicated by the manufacturer.
To carry out technical calculations and obtain the exact parameters of the goods, use the datasheets from the manufacturer's website.
If you need additional information, or you found an error in the description, or have other questions about this product, then our manager will help you: Денис - Днепр
unknown